Description The Schluter RENO RAMP Floor Transition Profile is the preferred solution for areas exposed to heavy vehicular traffic. Thanks to the flat incline–approx. 5° to 10° depending on the profile height and the shallow edge, the profile is well suited for forklift or lift truck traffic. It is also suited to create stepless transitions in areas that must comply with disabled access requirements. The Schluter RENO RAMP K is a profile without an anchoring leg designed for retrofitting. With a slope of approx. 8°, which can be adhered between the covering material and the substrate for subsequent height adjustment. The Schluter RENO RAMP is available in the following sizes, in 2.5 metre lengths: 6mm/50mm internal height/width 10mm/64mm internal height/width 12.5mm/64mm internal height/width 12.5mm/89mm internal height/width 15mm/89mm internal height/width 20mm/89mm internal height/width The Schluter RENO RAMP K is only available in one size: 12.5mm/64mm internal height/width The Schluter RENO RAMP is made of anodised aluminium and features an anodised finish that retains a uniform appearance during normal use. The finish may be damaged by aggressive substances or abrasive stresses. Since the effect of tile adhesive, mortar or grout may affect the finish, all contaminations must be removed immediately. Otherwise, the same description as for aluminium applies. Installation: Select the appropriate Schluter RENO RAMP Profile according to the tile thickness and the installation method. Fill the hollow space on the underside of the profile with tile adhesive. Apply tile adhesive to the area where the tile covering will end, using a notched trowel. Press the trapezoid-perforated anchoring leg of the Schluter RENO RAMP profile firmly into the adhesive and align it. Trowel tile adhesive over the trapezoid perforated anchoring leg to ensure full coverage. Firmly press the adjoining tiles into place and align them in such a way that the upper profile edge is flush with the tile (the profile should not protrude over the surface of the covering; preferably, it should be approx. 1 mm below the top level of the covering). The tiles must be fully embedded in the area of the profile. The tile is set to the lateral joint spacer, which creates an evenly spaced joint of 1.5 mm. In the case of stainless steel or brass profiles, a joint of approx. 1.5 mm is recommended. Completely fill the space between the tile and the profile with grout. Installation of the Schluter RENO RAMP K: Always check the substrates on which the profile is to be installed to make sure they are level, load-bearing, clean and compatible with the materials to be used. Remove all surface components that may weaken the bond. Apply a suitable tile adhesive or epoxy resin mortar on the substrate, fill the underside of the profile with adhesive and then fully embed the profile. Product Datasheet Click here to view this product on the Manufacturers website.
