Description The wedi Solso Shower Tray is a floor-level shower tray specifically developed for use with PVC coverings, to cope with the high pressure point loads. Manufactured from a highly dense polystyrene hard foam board with a special mortar coating, the wedi Solso Shower Tray has been designed to be ideally suited for the wet areas in hospitals as well as in private and public care institutions. The wedi Solso Shower Tray can easily take high pressure-point loads of up to 2.5 N/mm2, for example, exerted by wheelchairs or walking aids. It also offers the advantage that the entire system is far easier and faster to assemble than a classic design. Furthermore, the wedi Solso PVC surface can be attached to the drainage system without sticking and is waterproof. Where safety, wear resistance, stability and cost-efficiency are called for, the wedi Solso Shower Tray is the alternative, yet zero alternative, shower system for installation underneath PVC coverings. The wedi Solso Shower Tray is available in two sizes: 073738172 – 900 x 900 x 40mm, central drain 073738173 – 1200 x 1200 x 40mm, central drain Please note: the wedi Solso Shower Tray can only be used with the wedi Solso Shower Drain Kits. These offer a watertight connection system for PVC coverings. Technical Characteristics of the Foam: Highly close polystyrene expanded plastic slab. Maximum recommended compressive strength under service load: 2.50 N/mm2 Compressive strength at ≤ 2% long-term immersion in line with EN 13163: 3.78 N/mm2 Compressive strength at 10% compressive strain in line with EN 13163: 6.47 N/mm2 Thermal conductivity in line with EN 13164: 0.05 W/mK Bulk density in line with EN 1602: ≥ 280 kg/m3 Temperature limits: -20°C / 70°C Fire behaviour in line with DIN 13501-1: E Gas emissions: None Technical Characteristics of wedi Solso: Plate thickness (outer dimension) up to a shower size of 1200 × 1200 mm: 40 mm Residual indentation following constant loading (with PVC covering) in line with DIN EN 433: ≤ 0.10 mm Suitable for wheelchair loading: Yes Minimum installation depth for horizontal installation: 130 mm Minimum installation depth for vertical installation: 40 mm Surface slope (from outer edge of Solso building board to outer edge of drain opening): 18 mm = ≥ 3% Frame for holding stainless steel grate (fixed in the element): Ø 120 mm Stainless steel grate: Ø 115 mm Product Datasheet Installation Instructions Click here to view this product on the Manufacturers website.
