Description UltraTile ProGrout Flexible Tile Grout has been designed for areas where movement or vibration is likely. Polymer has been added to the formulation to increase flexibility and to provide a virtually impermeable set. UltraTile ProGrout Flexible is suitable for joint widths up to 20mm. UltraTile ProGrout Flexible Tile Grout is available in the following colours: Brilliant White, Vintage White, Ivory, Almond, Jasmine, Limestone, Taupe, Mocha, Silver Grey, Mid Grey, Grey, Dark Grey, Charcoal, Black. All colours are available in 3kg bags, with a a selection also available in 10kg bags. Matching silicone sealant in these colours is also available – UltraTile ProSealer Silicone Sealant. Surface Preparation: Ensure that the tile adhesive is completely set and that the tiles are firmly fixed. All joints should be free from excess adhesive, dust, grease or any other contaminants. Note: When working with tiles that have a highly porous backing / biscuit i.e. ceramic, it is recommended to either seal or pre wet the joints prior to applying UltraTile ProGrout Flexible Tile Grout to reduce absorption. Mixing: UltraTile ProGrout Flexible should be added slowly to clean water in a suitable mixing vessel in the approximate by volume ratio as indicated on the side. Mix until a smooth consistency is achieved, leave to stand for 2 minutes then remix. Do not mix more than can be used in a 30-45 minutes period, do not rewet or add too much water. This will cause a weakening of the grout and a tendency to crumble. In certain cases this may also lead to discolouration in the form of efflorescence. Application: UltraTile ProGrout Flexible Tile Grout should be applied to the surface using a rubber backed trowel or squeegee. Work the mixed material thoroughly into the joints a small area at a time. Ensure that the joints are completely filled without voids before continuing. Excess grout should be removed as grouting proceeds. Any residue left on the face of the tile can be removed by wiping with a damp sponge when the grout has started to firm (approximately 15 minutes – when using a normal ceramic tile. On non-absorbent tiles such as porcelain, this may take up to an hour). Any dry film remaining once the job is complete can be polished off the face of the tiles with a soft dry cloth. Finishing when the grout is not firm to the touch, may lead to joints being emptied or potential colour variation. If using in a shower area, UltraTile ProGrout Flexible Tile Grout must be allowed to fully cure for two weeks before using the shower area. Technical Data: Unit Size: 10kg & 3kg Bags Colours: Brilliant White, Vintage White, Ivory, Almond, Jasmine, Limestone, Taupe, Mocha, Silver Grey, Mid-Grey, Grey, Dark Grey, Charcoal and Black Classification: EN13888 CG2 WA Application Thickness: 1mm – 20mm Initial Drying Time*: 10-15 Minutes Pot Life*: 30-60 Minutes Light Foot Traffic*: 3-4 Hours Hard Set Time*: 12 Hours Application Temperatures: 5°C to 25°C *Depending on temperatures, substrate and site conditions. Product Datasheet Click here to view this product on the Manufacturers website.
