Description Schluter RONDEC PRO GS Black PVC Round Tile Trim is a symmetrically round profile that offers excellent edge protection for external corners of tiled walls. It is extruded from through-coloured PVC and has a graphite black colour finish. Available in the following internal height sizes: 6mm, 8mm, 10mm, 11mm, 12.5mm. All sizes come in 2.5 metre lengths. In addition to its decorative function, Schluter RONDEC PRO GS Black PVC Round Tile Trim effectively protects the edge areas from damage caused by mechanical impact. The visible area of the profile forms a right angled external corner for tile coverings. The integrated joint spacer of the profile forms a defined joint cavity with the tile. Matching prefabricated corner pieces, made from PVC, are available for internal and external corners for simple and appealing corner connections. Schluter RONDEC PRO GS Black PVC Round Tile Trim is made of pre coloured, rigid PVC which resists bending or scratching. The material is UV resistant, though not permanently colour stable, in exterior applications. The profiles are not suited for corners or transitions subjected to heavy mechanical loadings, e.g. at step edges or floor transitions. Installation: Select the profile height of Schluter RONDEC PRO GS Black PVC Round Tile Trim according to the tile thickness and the installation method. Apply tile adhesive to the area where the tile covering will end, using a notched trowel. If Schluter RONDEC PRO GS is to be installed in an external wall corner, complete the tiling of one wall, then apply tile adhesive in the corner area of the second wall. Press the perforated anchoring leg of Schluter RONDEC PRO GS firmly into the adhesive and align it. Trowel additional adhesive over the perforated anchoring leg to ensure full coverage and fill the profile chamber with tile adhesive. Fully embed the adjoining tiles and adjust them in such a way that the upper lip of the profile is flush with the tile. Note: The profile may slightly protrude or be recessed in the wall area to offset dimensional variations in the covering material. In floor areas, the profile should not be higher than the tiled surface, but rather up to approx. 1 mm lower. The tile is set to the lateral joint spacer, which creates an evenly spaced joint of 1.5 mm. In the case of stainless steel or brass profiles, a joint of approx. 1.5 mm is recommended. Fill the joint completely with grout. Use suitable materials and tools for the sensitive surfaces to avoid scratches or other damage. Setting materials must be removed immediately. Matching preformed inside and outside corner pieces are available. Maintenance: Schluter RONDEC PRO GS Black PVC Round Tile Trim requires no special maintenance or care. Abrasive cleaners should not be used on sensitive surfaces. Product Datasheet Click here to view this product on the Manufacturers website.
